Search bioRxiv⌕ Search

bioRxiv · 10.1101/2025.06.03.657760

Inference of VEGFR2 dimerization kinetics on the cell surface by integrating single-molecule imaging and mathematical modeling

Abstract

Inter-receptor interactions play a key role in receptor signaling, which is the first step in cell signaling in response to external stimuli. In the case of Vascular Endothelial Growth Factor Receptor 2 (VEGFR2), dimerization is necessary for activation. VEGFR2 undergoes reversible interactions also in the absence of ligand. For a quantitative understanding of transmembrane signal transduction, it is necessary to quantify the interaction kinetics of VEGFR2 on the cell surface. Live-cell single-molecule imaging (SMI) has the powerful ability to capture receptor interaction events in their native cellular environment with high spatiotemporal resolution. However, it reveals these interactions for only the labeled subset, which is a small fraction of the full population of receptors. We have previously shown that mathematical modeling, combined with SMI data, offers a route to compensate for this lost information and infer the population-level receptor interaction kinetics from SMI data. Here, we applied this approach to VEGFR2, both wildtype full length VEGFR2 (FLR2) and a truncated mutant consisting of its extracellular and transmembrane domains (ECTM), which has been shown to exhibit reduced homotypic interactions in the absence of ligand. We developed a stochastic mathematical model mimicking VEGFR2 diffusion and interactions and determined the unknown model parameters through a combination of direct experimental measurements and stochastic model calibration. We found that a model of dimerization was sufficient to describe VEGFR2 interactions in the absence of ligand. While ECTM was primarily monomeric, FLR2 exhibited a substantial fraction of dimers. Our inference revealed that the difference between FLR2 and ECTM was primarily in the dimer association rate constant, which was about an order of magnitude lower for ECTM than for FLR2. To our knowledge, this is the first time that the interaction kinetics of VEGFR2 have been calculated in live cells. Author summaryInteractions between receptors on the cell surface play a large role in the initiation and modulation of cell signaling. For example, the receptor VEGFR2 in vascular endothelial cells must dimerize as a first step toward signaling. However, many interactions, including VEGFR2 dimerization, also take place in the absence of ligand stimulation. Therefore, elucidating when and where receptor interactions take place, and what their kinetics are, is critical for understanding receptor and cell signaling, especially on a quantitative level. Determining interaction kinetics is particularly challenging, given that membrane proteins do not express well in vitro, and are thus not amenable to traditional biophysical methods that quantify molecular interactions. In addition, the membrane and cellular environment is much more complex than an in vitro setting. To address these challenges, we combine single-molecule imaging, stochastic mathematical modeling, and rigorous model calibration to derive the dimerization kinetics of VEGFR2 (both full-length and a truncation mutant with reduced dimerization) on the surface of live cells. To our knowledge, this is the first time that the interaction kinetics of VEGFR2 have been calculated in live cells. Our approach is generalizable to many other cell surface proteins, opening an avenue for quantifying molecular interaction kinetics in situ.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Guerrero, J., Malik, Z., Bilal, F., Jana, S., Dasgupta, A., Jaqaman, K.. 2025-06-05. Inference of VEGFR2 dimerization kinetics on the cell surface by integrating single-molecule imaging and mathematical modeling. https://doi.org/10.1101/2025.06.03.657760

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related preprints

Scaling of structural variability of ecDNA polymer condensates with copy number boosts and stabilises oncogene regulatory contacts

Extrachromosomal DNAs (ecDNAs) form highly heterogeneous condensates in cancer cells that drive oncogene overexpression, yet how structural variability coexists with stable gene regulation remains unclear. Here, we develop a minimal polymer physics model of MYC-harbouring COLO320-DM ecDNAs, where BRD4-like complexes bind and bridge cognate sites along ecDNA rings. Above a critical binder concentration, ecDNAs phase separate into condensates exhibiting diverse conformations because of their thermodynamic folding degeneracy. Despite this variability, condensates retain conserved interaction scaffolds that give rise to reproducible contact patterns, including in-trans associated domains (I-TADs), genomic regions enriched in intermolecular regulatory contacts between distinct ecDNAs. We find that condensate 3D architecture follows universal scaling relations with ecDNA copy number, n, remaining robust to model parameter changes. Regulatory contacts within I TADs increase linearly with n, yet they are one order of magnitude stronger than in size matched control regions outside I TADs, whereas their relative fluctuations are markedly suppressed as n increases. This scaling produces enhanced, low-noise regulatory environments for oncogenes embedded within I-TADs, such as PVT1-MYC fusions, whereas the canonical MYC copy, located outside, is less amplified as experimentally observed. Our findings reveal universal polymer physics principles underlying ecDNA condensate organization, offering a mechanistic basis for selective oncogene amplification and potential advantages in cancer progression.

biophysics↗

High-resolution mapping of RNA structural maturation during Cas9 assembly with ABEL-FRET

The structural flexibility of RNA is essential for forming ribonucleoprotein (RNP) complexes, which regulate diverse biological processes. This intrinsic property permits RNA to act as a dynamic scaffold along the assembly pathway as it folds into a specific structure for initial recognition by protein and undergoes conformational rearrangements for functional maturation as a complex. Yet, RNA flexibility and RNP multicomponent assembly create significant obstacles for traditional structural methods. To overcome these challenges, we applied recently developed ABEL-FRET spectroscopy to measure tether-free single-molecule Forster resonance energy transfer (smFRET) over extended observation times. Furthermore, ABEL-FRET enables the unique ability for simultaneous measurements of ultrahigh resolution smFRET and hydrodynamic size of individual complexes, which offers distinct advantages for studying dynamic RNA molecules that undergo assembly via sequential binding events. Using ABEL-FRET, we explored how the guide RNA (gRNA) of CRISPR genome editing system folds and modulates its structural flexibility to carry out the roles required for each assembly state from its unbound apo form to the functional Cas9 RNP state for target DNA cleavage. Multi-perspective view of gRNA structure gained by probing its two primary functional domains enabled to capture dramatic changes in gRNA flexibility that are highly dependent on its specific structural domains as well as assembly states. Collectively, our work with ABEL-FRET highlights the intrinsic link between the structural flexibility of RNA and its functionality in RNP assembly.

biophysics↗

De novo design of functional RNAs through higher-order interactions

Designing RNA sequences that reliably adopt functional three-dimensional structures remains a central challenge in RNA engineering because folding depends on cooperative interactions beyond canonical base pairing. Here we present DS3dRNA, an interaction-based framework for de novo RNA sequence design that combines a three-body statistical potential with physics-guided sequence sampling and supports design against multiple conformations. Across the evaluated benchmarks, DS3dRNA outperformed representative RNA inverse-design methods in native-sequence recovery and agreement between predicted and target structures. Energy-sequence-quality analyses further showed that lower design energies generally accompanied higher sequence recovery and macro-averaged F1 scores (MacroF1). Experimentally tested Mango II designs retained high-affinity fluorogenic activity, and five twister ribozyme designs yielded mean endpoint cleavage fractions of 37.7-50.6%, compared with 23.5% for the wild type. These results establish explicit higher-order interaction scoring as a complementary approach to emerging data-driven RNA design methods and provide a framework for designing functional RNAs from experimental or predicted structural ensembles.

biophysics↗