Search bioRxiv⌕ Search

bioRxiv · 10.1101/2020.09.28.316489

Manage flowering time in Miscanthus and sugarcane to facilitate intra- and intergeneric crosses

Abstract

Miscanthus is a close relative of Saccharum and a potentially valuable genetic resource for improving sugarcane. Differences in flowering time within and between Miscanthus and Saccharum hinders intra- and interspecific hybridizations. A series of greenhouse experiments were conducted over three years to determine how to synchronize flowering time of Saccharum and Miscanthus genotypes. We found that day length was an important factor influencing when Miscanthus and Saccharum flowered. Sugarcane could be induced to flower in a central Illinois greenhouse using supplemental lighting to reduce the rate at which days shortened during the autumn and winter to 1 min d-1, which allowed us to synchronize the flowering of some sugarcane genotypes with Miscanthus genotypes primarily from low latitudes. In a complementary growth chamber experiment, we evaluated 33 Miscanthus genotypes, including 28 M. sinensis, 2 M. floridulus, and 3 M. xgiganteus collected from 20.9{degrees} S to 44.9{degrees} N for response to three day lengths (10 h, 12.5 h, and 15 h). High latitude-adapted M. sinensis flowered mainly under 15 h days, but unexpectedly, short days resulted in short, stocky plants that did not flower; in some cases, flag leaves developed under short days but heading did not occur. In contrast, for M. sinensis and M. floridulus from low latitudes, shorter day lengths typically resulted in earlier flowering, and for some low latitude genotypes, 15 h days resulted in no flowering. However, the highest ratio of reproductive shoots to total number of culms was typically observed for 12.5 h or 15 h days. Latitude of origin was significantly associated with culm length, and the shorter the days, the stronger the relationship. Nearly all entries achieved maximal culm length under the 15 h treatment, but the nearer to the equator an accession originated, the less of a difference in culm length between the short-day treatments and the 15 h day treatment. Under short days, short culms for high-latitude accessions was achieved by different physiological mechanisms for M. sinensis genetic groups from the mainland in comparison to those from Japan; for mainland accessions, the mechanism was reduced internode length, whereas for Japanese accessions the phyllochron under short days was greater than under long days. Thus, for M. sinensis, short days typically hastened floral induction, consistent with the expectations for a facultative short-day plant. However, for high latitude accessions of M. sinensis, days less than 12.5 h also signaled that plants should prepare for winter by producing many short culms with limited elongation and development; moreover, this response was also epistatic to flowering. Thus, to flower M. sinensis that originates from high latitudes synchronously with sugarcane, the former needs day lengths >12.5 h (perhaps as high as 15 h), whereas that the latter needs day lengths <12.5 h.

Source connections

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Dong, H., Clark, L., Jin, X., Anzoua, K., Bagmet, L., Chebukin, P., Dzyubenko, E., Dzyubenko, N., Ghimire, B. K., Heo, K., Johnson, D. A., Nagano, H., Sabitov, A., Peng, J., Yamada, T., Yoo, J. H., Yu, C. Y., Zhao, H., Long, S. P., Sacks, E.. 2020-09-28. Manage flowering time in Miscanthus and sugarcane to facilitate intra- and intergeneric crosses. https://doi.org/10.1101/2020.09.28.316489

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related preprints

Secondary growth in the tomato stem is suppressed by the flowering regulators FUL2 and STM3

Herbaceous eudicot crops such as tomato accumulate substantial amounts of secondary xylem in their stems, particularly in the basal part. As plants progress from the vegetative phase to flowering and fruit development, secondary growth continues to provide mechanical support and facilitate transport. To uncover how secondary growth is regulated in the tomato stem, we used laser capture microdissection RNA-seq to establish tissue-specific transcriptomic profiles. This revealed that key regulators associated with wood formation in poplar are also acting in tomato. Furthermore, we found that the flowering regulators FUL2 and STM3 are substantially expressed in xylem tissue. Subsequent functional analysis identified FUL2 and STM3 as key repressors of secondary growth, with ful2 or stm3 knock-out mutants exhibiting strongly increased secondary growth in older tomato stems. Notably, a higher order mutant in which both ful2 and stm3 were knocked out displays a similar non-additive phenotype, indicating, together with yeast two-hybrid data showing physical interaction, that FUL2 and STM3 act together in a complex. The expression levels of both genes remain low until after the floral transition but strongly rise during subsequent stem development. Transcriptomic analyses in ful2, stm3, and wild-type stems at stages before and after detectable anatomical differences, showed that the FUL2-STM3 complex represses distinct sets of NAC and MYB candidate regulators associated with xylem development. Interestingly, FUL2 and STM3 control these regulators in a stage- and position-dependent way, with candidates showing upregulation only at later stages in mid-height stems being already upregulated at earlier stages in basal stem regions. Our findings provide a tissue-resolved transcriptomic resource for tomato stems and reveal a role for FUL2 and STM3 in limiting secondary xylem accumulation as stem development progresses.

plant biology↗

Geometric Morphometrics of Pistillate Flowers in Astrocaryum sect. Huicungo (Arecaceae): Taxonomic Implications for the Peruvian Species

The taxonomy of the Amazonian palm clade Astrocaryum sect. Huicungo remains controversial due to deep discordances between traditional classifications based on qualitative floral traits and recent phylogenomic evidence. To address this, landmark-based two-dimensional geometric morphometrics (4 landmarks, 16 semilandmarks) was applied to evaluate the symmetric component of shape variation in calyx and corolla structures across 549 pistillate flowers from the 11 Peruvian species. Although multivariate analyses (PCA, CVA) revealed continuous morphological variation and extensive phenotypic overlap, perianth geometry retained a significant diagnostic signal. Cross-validated classification rates demonstrated that the corolla exhibited higher discriminatory power than the calyx, while the combined perianth analysis (calyx + corolla) maximized taxonomic assignment accuracy. Furthermore, Mahalanobis distance-based clustering did not replicate traditional subsections: A. chonta and A. ulei exhibited divergent architectures, whereas A. carnosum, A. faranae, and A. huicungo shared profound geometric similarity. This study demonstrates that quantitative perianth morphometrics is a valuable tool for species delimitation in Astrocaryum, supporting the re-evaluation of traditional taxonomic boundaries through an integrative approach.

plant biology↗

Multi-Criteria Evaluation of Hibiscus mutabilis Cultivars for Food Development Using Delphi and Analytic Hierarchy Process

This study evaluated 11 Hibiscus mutabilis cultivars from Chengdu Botanical Garden to assess their quality for food use and identify promising cultivars. An evaluation framework was developed using the Delphi method to select indicators and the analytic hierarchy process (AHP) to determine their weights. Overall scores ranged from 2.5785 to 3.6043, and the cultivars were classified into three grades. Grade I included Hibiscus mutabilis 'Bairi Huacai', Hibiscus mutabilis 'Chongbanbai' and Hibiscus mutabilis 'Jinqiusong'; Grade II included Hibiscus mutabilis 'Jinqiuhong', Hibiscus mutabilis 'Zuifurong', Hibiscus mutabilis 'Danbanhong', Hibiscus mutabilis 'Jinxiuzi', Hibiscus mutabilis 'Jinbiyu' and Hibiscus mutabilis 'Caixia'; whereas Grade III included Hibiscus mutabilis 'Mudanfen' and Hibiscus mutabilis 'Jinrui'. In summary, Hibiscus mutabilis 'Bairi Huacai', Hibiscus mutabilis 'Chongbanbai' and Hibiscus mutabilis 'Jinqiusong' are the preferred cultivars for food processing and development. The framework provides a basis for cultivar screening and further evaluation of H. mutabilis flowers for food use.

plant biology↗