Sterol-lipids enable large-scale, liquid-liquid phase separation in membranes of only 2 components
Despite longstanding excitement and progress toward understanding liquid-liquid phase separation in natural and artificial membranes, fundamental questions have persisted about which molecules are required for this phenomenon. Except in extraordinary circumstances, the smallest number of components that has produced large-scale, liquid-liquid phase separation in bilayers has stubbornly remained at three: a sterol, a phospholipid with ordered chains, and a phospholipid with disordered chains. This requirement of three components is puzzling because only two components are required for liquid-liquid phase separation in lipid monolayers, which resemble half of a bilayer. Inspired by reports that sterols interact closely with lipids with ordered chains, we tested whether phase separation would occur in bilayers in which a sterol and lipid were replaced by a single, joined sterol-lipid. By evaluating a panel of sterol-lipids, some of which are found in bacteria, we discovered a minimal bilayer of only two components (PChemsPC and diPhyPC) that robustly demixes into micron-scale, liquid phases. It suggests a new role for sterol-lipids in nature, and it reveals a membrane in which tie-lines (and, therefore, the lipid composition of each phase) are straightforward to determine and will be consistent across multiple laboratories. Significance StatementA wide diversity of bilayer membranes, from those with hundreds of lipids (e.g., vacuoles of living yeast cells) to those with very few (e.g., artificial vesicles) phase separate into micron-scale liquid domains. The number of components required for liquid-liquid phase separation has been perplexing: only two should be necessary, but more are required except in extraordinary circumstances. What minimal set of molecular characteristics leads to liquid-liquid phase separation in bilayer membranes? This question inspired us to search for single, joined "sterol-lipid" molecules to replace both a sterol and a phospholipid in membranes undergoing liquid-liquid phase separation. By producing phase-separating membranes with only two components, we mitigate experimental challenges in determining tie-lines and in maintaining constant chemical potentials of lipids.