Non-destructive tree volume estimation using mobile laser scanning: Impact of the tree shape on measurement error.
Accurate tree volume estimation is central to forest management and carbon accounting. Allometric equations are widely used but limited in transferability across species, regions, and environmental conditions. Mobile Laser Scanning (MLS) offers a promising alternative through direct measurement of tree geometry; however, the influence of tree shape on MLS accuracy remains poorly understood. This study evaluated MLS-derived estimates of stem diameters, total tree height, and merchantable stem volume against destructive reference measurements from 176 trees spanning eight species (four hardwood, four softwood) in Wallonia, Belgium. A Zeb Horizon RT scanner was used; tree architectural descriptors extracted from the point cloud were tested for associations with measurement error. Across 7,824 stem diameter measurements, MLS achieved a mean error of 0.46 cm, with precision declining above 15 m. MLS-derived height outperformed Vertex IV clinometer measurements for hardwood species (RMSE% = 6.88 vs. 8.78) but performed slightly less well for softwoods (RMSE% = 7.36 vs. 6.14). QSM-based volume estimates systematically underestimated reference values, while taper-based reconstruction produced nearly unbiased estimates with an RMSE of 15.72%. Correlation analyses and PCA showed that tree architectural variables explained only a small fraction of MLS error variability. Diameter and height errors were largely independent of structural attributes, while volume errors showed moderate associations with tree size and crown density. These findings indicate that tree architecture is not a primary source of MLS measurement uncertainty. Future MLS-based forest inventory efforts should prioritize acquisition and processing optimization, as scanning conditions and forest structure appear more influential than tree shape.