Biology subjects

Amos, W. B.

Publications and source records attributed to Amos, W. B..

9 recordsLinked to original sources

bioRxiv2026

A method for correcting background non-uniformity while preserving specimen-level information in Fourier ptychographic microscopy images

Fourier ptychographic microscopy (FPM) enables high resolution imaging across large fields of view, but reconstructed images often exhibit background non-uniformity that interferes with quantitative image analysis. Here, a post-reconstruction background correction approach is presented that identifies specimen-containing regions and corrects only the surrounding background, leaving specimen pixel intensities unchanged. The method was effective across amplitude and phase reconstructions of multiple biological specimen types with no loss in image resolution. The method also improved object detection compared with analysis of the uncorrected image data. FPM background correction reduced residual background non-uniformity to 0.61% with only 0.04% structural error, compared with 6.13% structural error for pseudo flat field correction. These results demonstrate that FPM background correction can support more accurate quantitative analysis of FPM image data while preserving specimen information and image resolution, enabling more reliable segmentation and measurement across large fields of view.

biophysics↗

bioRxiv2025

A large 3D-printed integrated lens-biprism element enhances contrast in transmission stereomicroscopy

Stereomicroscopes are routinely used across disciplines for material and surface characterisation due to their simplicity of use and minimal specimen preparation requirements. However, the stereomicroscope transillumination design is suboptimal, as a single incident beam at the specimen plane is shared and transmitted via two laterally offset detection axes. This flaw limits life science applications due to the transparent nature of samples which results in poor contrast images. We use a single additional element in the illumination path to correct the illumination uniformity across the field of view and, by doing so, enhance image contrast and facilitate detection of refractive structures in transparent biological specimens. We designed and fabricated an integrated lens-biprism element using low-cost, consumer-grade 3D printing methods and consumables. This 3D printed lens-biprism distributed diverging rays from a single incandescent light source into two parallel beams that converged at the specimen plane and transmitted through the respective left and right detection axes of a stereomicroscope. This improved transillumination setup increased the image contrast by up to 67.62% compared to the conventional stereomicroscope setup. We demonstrated the benefit of the lens-biprism element by visualising dynamic cellular events in live tissue and discerning refractive structures more easily in transparent specimens.

biophysics↗

bioRxiv2025

PerfectlyAverage: a classical open-source software method to determine the optimal averaging parameters in laser scanning fluorescence microscopy

Laser scanning fluorescence microscopy (LSFM) is a widely used imaging method, but image quality is often degraded by noise. Averaging techniques can enhance the signal-to-noise ratio (SNR), but while this can improve image quality, excessive frame accumulation can introduce photobleaching and may lead to unnecessarily long acquisition times. A classical software method called PerfectlyAverage is presented to determine the optimal number of frames for averaging in LSFM using SNR, photobleaching, and power spectral density (PSD) measurements. By assessing temporal intensity variations across frames, PerfectlyAverage identifies the point where additional averaging ceases to provide significant noise reduction. Experiments with fluorescently stained tissue paper and fibroblast cells validated the approach, demonstrating that up to a 4-fold reduction in averaging time may be possible. Data are also presented to suggest that frame and line averaging with the same number of averages may produce different results, and this may influence the optimal number of averages. PerfectlyAverage is open source, compatible with any LSFM data obtained using line or frame averaging during image acquisition, and it is aimed at improving imaging workflows while reducing the reliance on subjective criteria for choosing the number of averages.

cell biology↗

bioRxiv2023

Printing, Characterising, and Assessing Transparent 3D Printed Lenses for Optical Imaging

High-quality lens production has involved subtractive manufacturing methods for centuries. These methods demand specialist equipment and expertise that often render custom high-grade glass optics inaccessible. We aimed to develop a low-cost, accessible, and reproducible method to manufacture high-quality three-dimensional (3D) printed lenses using consumer-grade technology. Various planoconvex lenses were produced using a consumer-grade 3D printer and low-cost spin coating setup, and printed lenses were compared to commercial glass counterparts. A range of mechanical and optical methods are introduced to determine the surface quality and curvature of 3D printed lenses. Amongst others, high-resolution interference reflection microscopy methods were used to reconstruct the convex surface of printed lenses and quantify their radius of curvature. The optical throughput and performance of 3D printed lenses were assessed using optical transmissivity measurements and classical beam characterisation methods. We determined that 3D printed lenses had comparable curvature and performance to commercial glass lenses. Finally, we demonstrated the application of 3D printed lenses for brightfield transmission microscopy, resolving sub-cellular structures over a 2.3 mm field-of-view. The high reproducibility and comparable performance of 3D printed lenses present great opportunities for additive manufacturing of bespoke optics for low-cost rapid prototyping and improved accessibility to high-quality optics in low-resource settings.

biophysics↗

bioRxiv2022

MesoTIRF: a Total Internal Reflection Fluorescence illuminator for axial super-resolution membrane imaging at the mesoscale

Total Internal Reflection Fluorescence (TIRF) illumination bypasses the axial diffraction limit of light by using an evanescent field to excite fluorophores close to a sample substrate. TIRF illumination significantly improves image contrast, allowing researchers to study membrane structure and dynamics with localized reductions in photobleaching. However, a significant limitation of most TIRF microscopes is the relatively small field of view (FOV). TIRF objectives require a high numerical aperture (NA) to generate the evanescent wave. Such lenses invariably have a high magnification and result in a [~] 50 {micro}m diameter imaging field, requiring many subsequent images for accurate statistical analysis. Waveguide and prism-based TIRF systems are, in principle, compatible with lower magnification lenses to widen the FOV but these have a correspondingly low NA and lateral resolution. To overcome these limitations, we present a prism-based TIRF illuminator for the Mesolens - a specialist objective lens with the unusual combination of low magnification and high NA. This new imaging mode - MesoTIRF - enables TIRF imaging across a 4.4 mm x 3.0 mm FOV. We demonstrate evanescent wave illumination of cell specimens, and show the multi-wavelength capability of the modality across more than 700 cells in a single image. MesoTIRF images have up to a 6-fold improvement in signal-to-background ratio compared to widefield epi-fluorescence illumination, and we illustrate the benefit of this improved contrast for the detection and quantification of focal adhesions in fixed cells. Fluorescence intensities and resolvable structural detail do not vary considerably in homogeneity across the MesoTIRF FOV.

biophysics↗

bioRxiv2019

Functional channels in mature E. coli colonies

Biofilms are important in medicine, industry and the natural environment, however their structure is largely unexplored across multiple spatial scales. We have studied the architecture of mature Escherichia coli macro-colony biofilms by means of the Mesolens, an optical system which uniquely allows simultaneous imaging of individual bacteria and over one hundred cubic millimetres of its biofilm milieu. Our chief finding is the presence of intra-colony channels on the order of 10 m in diameter in E. coli biofilms. These channels have a characteristic structure and reform after total mechanical disaggregation of the colony. We present evidence that the channels transport particles and function to assist the absorption of nutrients. These channels potentially offer a new route for the delivery of dispersal agents or antimicrobial drugs to biofilms, ultimately lowering their impact on public health and industry.

microbiology↗

bioRxiv2019

Three-dimensional observations of an aperiodic oscillatory gliding motility behaviour in Myxococcus xanthus using confocal interference reflection microscopy

The Delta-proteobacterium, Myxococcus xanthus, has been used as a model for bacterial motility and to provide insights of bacterial swarming behaviours. Fluorescence microscopy techniques have shown that various mechanisms are involved in gliding motility, but these have almost entirely been limited to 2D studies and there is currently no understanding of gliding motility in a 3D context. We present here the first use of confocal interference reflection microscopy (IRM) to study gliding bacteria, and we reveal aperiodic oscillatory behaviour with changes in the position of the basal membrane relative to the coverglass on the order of 90 nm in vitro. Firstly, we use a model plano-convex lens specimen to show how topological information can be obtained from the wavelength-dependent interference pattern in IRM. We then use IRM to observe gliding M. xanthus and show that cells undergo previously unobserved changes in their height as they glide. We compare the wild-type with mutants of reduced motility, which also exhibit the same changes in adhesion profile during gliding. We find that the general gliding behaviour is independent of the proton motive force-generating complex, AglRQS, and suggest that the novel behaviour we present here may be a result of recoil and force transmission along the length of the cell body following firing of the Type IV pili.

microbiology↗

bioRxiv2018

Fast Optical Sectioning for Widefield Fluorescence Mesoscopy with the Mesolens based on HiLo Microscopy

We present here a fast optical sectioning method for optical mesoscopy based on HiLo microscopy, which makes possible imaging of specimens of up to 4.4 mm x 3 mm x 3 mm in volume in under 17 hours (estimated for a z-stack comprising 1000 images excluding computation time) with subcellular resolution throughout. Widefield epifluorescence imaging is performed with the Mesolens using a high pixel-number camera capable of sensor-shifting to generate a 259.5 Megapixel image, and we have developed custom software to perform HiLo processing of the very large datasets. Using this method, we obtain comparable sectioning strength to confocal laser scanning microscopy (CLSM), with sections as thin as 6.8{+/-}0.2 m and raw acquisition speed of 1 minute per slice which is up to 30 times faster than CLSM on the full field of view (FOV) of the Mesolens of 4.4 mm with lateral resolution of 0.7 m and axial resolution of 7 m. We have applied this HiLo mesoscopy method to image fixed and fluorescently stained hippocampal neuronal specimens and a 5-day old zebrafish larva.

biophysics↗

bioRxiv2018

Application of the Mesolens for sub-cellular resolution imaging of intact larval and whole adult Drosophila

In a previous paper (McConnell et al., 2016) we showed a new giant lens called the Mesolens and presented performance data and images from whole fixed and intact fluorescently-stained 12.5-day old mouse embryos. Here we show that using the Mesolens we can image an entire Drosophila larva or adult fly in confocal epifluorescence and show sub-cellular detail in all tissues. By taking several hundreds of optical sections through the entire volume of the specimen, we show cells and nuclear details within the gut, brain, salivary glands and reproductive system that normally require dissection for study. Organs are imaged in situ in correct 3D arrangement. Imaginal disks are imaged in mature larvae and it proved possible to image pachytene chromosomes in cells within ovarian follicles in intact female flies. Methods for fixing, staining and clearing are given.

developmental biology↗